Overhaul Project from October 2014 to January 2015

1997 Camaro RS 3.8 series II complete engine overhaul bored .030" over and ground to .010" under on mains and rods Hastings rings, sealed power pistons and bushings, engine tech main and rod bearings, melling oil pump and cam bearings FELPRO gasket set new fan assembly, tie rods in and out, and k-member
More March 31

Pulled out
Reconditioned block main bearing clearances and end play checked crank installed
Rod clearances checked pistons installed
Lifters, pushrods, rocker arms, heads, and lower intake manifold installed
Timing cover installed
Assembly complete
Back home
Bare block
Disassembly
Chevrolet red orange
Camshaft, balance shaft and timing kit installed
Harness installed and dropped in
Snug fit